Lightning cryptocurrency exchange
Chainlink is a cryptocurrency based on the Ethereum blockchain. The LINK token inherits the functionality of the ERC-20 standard, although it itself complies with the ERC-677 standard.
Chainlink (LINK) is the first decentralized oracle service of its kind. The ChainLink project allows smart contracts to use ChainLink oracle services to interact with systems of other payment networks using various APIs.
LINK smart contract
Do not submit LINK through a third party contract. Our exchanger does not accept transactions that are sent by third party smart contracts, except for the original LINK contract.
To work with tokens, the wallet must have ETH. It is very difficult to calculate the exact amount of ETH to send a transaction. During periods of high load, it can change significantly. Each token can have a different transaction value. Therefore, it is better that the amount of ETH on the wallet is slightly higher than the average fee on the network at the moment. The average fee can be estimated using the Blockchair analytical service.
The system does not see the transaction, what should I do?
If you have sent funds, but there are no changes, check your transaction in an explorer (etherscan.io or blockchair.com) and make sure that the transaction was created.
If the transaction has already been added to the blockchain, and the system has not seen it, contact technical support, we will be able to help you promptly.
Monero is the most anonymous cryptocurrency
Monero runs on the CryptoNote algorithm, unlike public blockchains (e.g. Bitcoin, Ethereum etc.), when sending it, you can not see the sender, the recipient, or even the amount that was sent. This is possible due to the use of Ring Signatures and Stealth Addresses technologies.
What to do if you did not receive Monero after the exchange?
First, make sure that the order contains data about the transaction sent. In case there is no transaction data, try to wait a bit or contact technical support. Due to the fact that in the Monero network updates from November 30 at the protocol level, funds are blocked until 10 network confirmations are received, delays in payment may sometimes occur.
Secondly, check the synchronization of your Monero wallet. The last block in the wallet should correspond to the number indicated on the MoneroHash website in the “Blockchain Height” field of the “Network” block. If not, try restarting your wallet.
If the order contains the data of the transaction we sent, the wallet is synchronized, but the transaction is not visible in the wallet, contact technical support to request a private viewing key to decrypt the transaction and confirm the sending of funds.
When can I use the resulting Monero?
As mentioned above, in the Monero network updates dated November 30 at the protocol level, funds are blocked until 10 network confirmations are received. That is, until the transaction receives 10 confirmations, it will not be possible to use the funds received. On average, a transaction receives 10 confirmations within 20 minutes.
Transaction processing speed
The average block release time is about two minutes. But sometimes delays do occur, and the block exit time can take 10-20 minutes.
exchange in 3 easy steps
- Enter the desired amount of Chainlink (ERC20) and write your wallet address to receive currency.
- Click the “Exchange now” button and you will be taken inside your order.
- Send Chainlink (ERC20) to the address from your order, after the required network confirmation, Monero will be sent instantly.